Anti-wear anti-flashover tape_Fujian Zhongcheng Ruibo Power Technology Co., Ltd.

< Back to listRB-FPTAnti-wear anti-flashover tape

RB-FPT

Anti-wear anti-flashover tape

Product specifications：

Width 50mm, thickness 1.65mm, length 3m/roll

Product introduction：

It is used on the cable in contact with insulator in overhead line to greatly reduce the potential danger of pollution flashover caused by salt mist, pollution, etc. , with excellent salt spray corrosion resistance, UV resistance, wear resistance and waterproof sealing, can greatly slow down the formation of flashover process, operation and maintenance personnel have enough time to find and eliminate the potential hazards that may lead to the formation of flashover.

Consulting products

Product Features
Technical Parameters
Application scenarios
Installation Notes

1.Salt spray corrosion: Can Run in the salt spray environment for a long time, no rust, blistering, cracking
2.Wear resistance: long time friction with rigid materials, almost no mass loss, effective against outdoor friction conditions
3.UV weather resistance: Long-term operation in outdoor al-weather environment, no obvious changes
4.Waterproof and sealing: special wear-resistant rubber lining and sealing cement three-layer composite structure, can provide reliable waterproof and sealing (IPX8)

	Performance indicators	Typical values
1	Tensile strength	≥8.8MPa
2	Elongation at break	≥400%
3	Thermal aging test（100℃/168h）	No cracking
4	Tear strength	≥20kN/m
5	Waterproof grade	IPX8
6	Abrasion resistance	Weight loss≤0.01g
7	Flame retardant grade	V-0
8	Resistant to chemical reagents (water,acid, alkali,salt)	No significant change
9	Electrical strength	≥10kV/mm
10	Hydrophobic	HC1 level
11	Resistance to frequency wet flashover vol tage	Test voltage≥100kV
12	Salt spray resistance test	≥240h
13	Resistant to ultraviolet aging	≥1000h

1.It is used on the cable which is in contact with insulator in 10KV overhead line of distribution network, greatly reducing the potential danger of pollution flashover caused by salt mist and pollution

2.Other scenes that need anti-flashover